0Item(s)

You have no items in your shopping cart.

Product was successfully added to your shopping cart.

Instructions

DIY guide to your own custom-made lamp

Assembly instructions for your customized light.


Required tools

Start with all the right tools:


Step 1

STRIP YOUR CABLE

Wrap some tape about 2 cm from the end of the cable.
Carefully cut away the fabric and the (outer) rubber layer,
so the two copper wires become visible.

Now, use a wire stripper to strip about 0,5 to 1 centimeter of the copper wires.
If you don't have a wire stripper, it is best to use scissors.
Be careful not to cut through the wires.


Step 2

TIGHTEN THE STRAIN RELIEF

Take the strain relief and screw it into the top of the lamp holder.
If it takes a lot of strength to completely tighten the strain relief,
use your screwdriver as a tool.

Step 3

MOUNT THE LAMP HOLDER

Open your lamp holder and pull the stripped cable through the top of the lamp holder.
Then tighten the stripped copper wires into the lamp holder using the small screws, finish by closing the lamp holder.
Finally, tighten the small screw of the strain relief to make sure your cable and lamp holder are well connected.
Now your lamp holder is ready to use!


Step 4

STRIP THE CABLE

Now, instead of 2 centimeters, strip at least 3 centimeters of the other side of the cable.
Again, use the the wire stripper or scissors to strip the copper wires.

Step 5

MOUNT YOUR CEILING ROSE

Shove the ceiling rose over your cable.
As a final step, pull the end of the cord through the small openings of the ceiling strain relief.

Now your lamp is ready to be hung from the ceiling.


Step 6

CONNECT YOUR LAMP

But first... Make sure the power is off!!!

Now it's time to connect the lamp.
You can use a simple wire connector to do this.
Finally, hang the strain relief on the ceiling hook and the job's done!


Step 7

SCREW IN YOUR BULB

Place your bulb into the lamp holder,